A traditional classic hanger design for classic half round copper gutter system made in the USA.   This hanger is known as the #10 Combo Hanger and is used for mounting half round gutter to plumb fascia boards.  Recommended hanger spacing is 24" on centers.  Includes brass spring clips for attachment to outer half round bead.  This classic design can also be used on 6" Half Round Reverse Bead profiles too.   See 'Related items' for hanger alternatives.

Installs to plumb fascia
Fits 6" Single Bead & Reverse Bead Half Round profiles

Suggested Price . . . $ 34.00

Use for hanging our six inch half round copper gutters on slanted fascia, no fascia, rafter tails, roof sheeting and crown molding scenarios.  Requires a copper shank.  Recommended hanger spacing is 24" on centers or less for roofs prone to snow loads  See 'Related items' for matching shanks and components.  Available copper shanks include needed include #1, #6, #10, #11, #12, #25, and # 30.  

Fits 6" Half Round (Traditional & Reverse Bead)
Do not use with 6" European Half-Round
 

Go to eHelp/Support > Installation >Half Round Hanger Detail PDF for diagram of all shank applications

Suggested Price . . . . . $ 29.00

Use this shank with our #1 Circle Copper Hanger bracket when installing to slated fascia or rafter tails.  One shank is required per hanger bracket. Allows half round gutter to hang plumb when installing directly to either slanted fascia or rafter end. Recommended spacing is 24" o.c.

Slanted Fascia Mounting shank  

Suggested Price . . .  $ 24.00

Use for installing copper half round gutter to roof's sheeting/underlayment or plumb rafter bottoms. Shank angle is 1/3 Pitch . Made from high grade copper. Requires a #1 Copper Gem Circle Hanger with Spring Clip.  Hardware not included.  Recommended hanger spacing is 24" o.c.

Use for Roof Mounting to roof with 4/12  or similar pitch
Requires a #1 Copper Circle Gem Hanger 

Suggested Price . . . . . $ 18.00

Use the #11 Copper Shank for attaching #1 Circle with Spring Clip, Nut & Bolt to exposed rafter. Made from high grade copper. One shank required per #1 Circle. Recommended spacing is 24" o.c. per hanger.

Side Rafter Mounting Shank

Suggested Price . . . . . $ 18.00

Requires a 5" or 6" #1 Copper Circle with Spring Clip, Nut & Bolt. Used when installing half round copper gutter. The #10 Copper Shank allows adjustable vertical hang on plumb fascia. Often used with tile and slate roofs with a high roof pitch.

Allow more vertical adjustment.  Steeper roofs with limited fascia.

Suggested price . . . . . $ 16.00

Our 6" half round single bead copper end cap fits both traditional bead and reverse bead 6" half round gutter. Made from 16oz. copper. May be used on either end of half round gutter. Must be sealed by solder or the use of Parbond. Two end cap are typically required per gutter run.

Fits 6" Half Round gutter profiles

Suggested Price . . .  $ 13.99